Canning 101

jars of jam

These are the basic steps in hot water bath canning which means boiling the filled jars until they are hermetically sealed. This vacuum-packed seal, along with the acidic contents keeps the food safe from bacteria and in particular clostridium botulinum.

Whenever we 'can' or preserve jams and pickles in this way they can be stored in a cool, dark place for a year or more, and do not have to be put in the fridge until they are opened. The hot water bath canning method only works safely with high-acid foods, i.e. fruit preserves & pickles, and will apply to everything that we can here and at tigress in a pickle. So please for safety reasons, follow the recipes and these directions completely and accurately, or, you can put your preserves directly in the fridge and skip this part.

But, this is the fun part. In fact
you'll most likely have a ball!

Steps in hot water bath canning

1. clean jars with hot soapy water or in the dishwasher.

2. pre-heat jars by placing open, empty jars on rack in the canning pot and lower down. Or, if you do not have a rack, you can place some screw tops down first, the object is to keep the jars from touching the bottom of the pan. fill canning pot with hot water until the jars are full. Place a lid on the canning pot and heat on the cooktop until hot but not boiling.

metal screw caps


note on sterilizing jars:
if the recipe states to boil the filled jars for 10 minutes or longer then the jars do not have to be sterilized at this step. If the recipe states to boil the filled jars for less than 10 minutes then you will want to sterilize them here - just boil the empty jars for 10 minutes at a full rolling boil.

3. prepare a recipe while jars are heating, keeping jars hot until ready to be filled.

4. heat jar tops 5 minutes before jars are to be filled. Place flat lids of mason jars, or the rubber gaskets for weck jars in a bowl with hot water (this water should not be boiling). Do not place metal screw caps in heated water, but you should place the weck glass tops in the heated water also if using.

5. remove each jar as needed when food is ready to be processed. My rack hangs on the side of the pot so I lift the entire thing up for easy access to the jars. This is where either a jar lifter or a silicone glove comes in handy. Place a folded kitchen towel on the counter and place a hot jar on the towel (a hot jar placed directly on a cold countertop could break). No need to dry the jar before filling. I turn it upside down and give it a couple of pats on the towel to shake out any excess water.

6. fill jars one by one. Food can either be ladled or sometimes poured into a jar. Here is where I use my trusty funnel. Headspace is very important: too much space between food and top of the jar and it may not seal correctly, too little and the food may be forced out of the jar during boiling. As a general rule, 1/2 inch headspace is perfect. Unless otherwise stated in the recipe food should always be processed immediately following the cooking stage, i.e. still hot.

7. remove air pockets by running a small rubber spatula or chopstick around the side of the jar. For most jams you will not have to do this, but if there are large pieces of fruit, or with most pickles, you will notice air pockets and will want to get rid of them to ensure a proper seal.

8. place lids on jars after wiping rim with a damp paper towel to remove any misplaced food. Place the flat lid on if using mason jars, or the rubber gasket and glass lid if using weck jars. for the masons put the screwcaps on and tighten with fingertips. this means that you want the screw cap secure but not overly tight. For the weck's once you have the rubber gasket encircled around the inside of the glass top and placed on top of the jar, put two metal clips on, directly across from each other.

empty glass jars

9. adjust water to cover by 1 inch once jars are full and lowered back down into the pot. If you have different size jars in the canner, cover the tallest one by 1 inch. Note that jar size should not vary too much within a recipe.

10. process jars according to an individual recipe as processing times vary and are based on the size of jars, density, and composition of the food. Processing is the amount of time the jars must be immersed in a full rolling boil. So the timing does not start until the boiling becomes steady & vigorous, and the water must remain at a full rolling boil throughout. A kitchen timer is helpful here for accuracy. For safety reasons and to ensure that the food does not overcook, do not alter the processing time.

Note on high altitude canning: the higher your elevation, the lower the temperature at which water boils. If you are over 1000ft adjust as follows: *

1001-3000 ft: increase processing time by 5 minutes
3001-6000 ft: increase processing time by 10 minutes
6001-8000 ft: increase processing time by 15 minutes
8001-10,000 ft: increase processing time by 20 minutes

11. leave jars in the pot for 5 minutes at end of processing time. Once the heat is off and the lid is lifted, a few minutes here will allow for adjustment to temperature change. I lift the rack up and hangover sides so that the jars are not in the water, but they can be left down below also.

12. lift jars out of canning pot with either a jar lifter or using a silicone glove and place on kitchen towels. Try not to tilt jars excessively. Do not adjust the screw caps or metal clips, do not worry about any water gathered on top of jars. Let jars rest for 12 to 24 hours to cool completely. You may hear popping noises from the masons, this is the sound of the jar sealing. :)

jar

13. check the seals after the 12 to 24 hour cooling period. For the masons push down in the center of the lid, you should not hear a metal popping noise, and it should concave slightly. For the wecks, the tab on the rubber gasket should be pointing down. Take off the screw caps or the metal clips and here is the real test: use your fingertips to pick up the jars by the lid only. If it is properly sealed you will be able to do this, if it isn't the lid will come off and the contents of the jar will spill everywhere. So do it slowly and with your other hand under the jar.

note on unsealed jars: if any jars failed to seal, you can wipe the rim and try again using a new flat-top or rubber gasket. If it is only one or two jars the easiest solution might be to put them directly in the fridge and enjoy immediately, as in some cases reprocessing overcooks the food and affects quality.

14. store the jars in a cool, dark place without the screw caps or metal clips. this means out of direct light and in a temperature range of 55 to 78 for best keeping quality. labeling the jars with date and contents is important because no matter how much you think you will remember what is what, you won't. trust me.

food in jars

15. examine each jar before opening by checking for bulging or leakage, and rechecking the seal as described above. if the seal has come undone or you notice anything funny, do not eat contents, discard food and sterilize the jar. screw caps or metal clips should be refastened after opening for fridge storage.

Don't let this last bit scare ya, or that link above. Because if you follow these steps and the recipes completely and accurately you will have many jars of good and safe eats!

for a list of tigress' picks for canning equipment go here.

just so you know, I picked some rhubarb yesterday and if this damn post didn't take so long I was gonna give you a recipe.
but safety first...so read up, cause I'm not doing this for my health ya know
...oh wait, I am
and yours too!

*: these are USDA recommended high altitude guidelines. Please note that some reliable sources do not adhere to the above, rather, they recommend adding 1 minute per every 1000 feet over 1000 feet above sea level. For example, a 10 minute processing time at sea level to 1000 feet would be 11 minutes at 1001-2000 feet above sea level, 12 minutes at 2001-3000 above sea level, etc.

Comments (0)

0
Rich text editor